To Exit Remote Start Mode And Drive The Vehicle
Before the end of the 15-minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, insert the key into the ignition switch and turn the switch to the ON/RUN position.
NOTE: The ignition switch must be in the ON/RUN position in order to drive the vehicle.
See also:
At Each Oil Change
• Change the engine oil filter.
• Inspect the brake hoses and lines.
• Check the manual transmission fluid level.
CAUTION!
Failure to perform the required maintenance items may result in dam ...
Base System
The Tire Pressure Monitor System (TPMS) uses wireless
technology with wheel rim mounted electronic sensors to
monitor tire pressure levels. Sensors, mounted to each
wheel as part of the valve st ...
Tire And Loading Information Placard Location
NOTE: The proper cold tire inflation pressure is listed
on the driver’s side B-Pillar or the rear edge of the
driver’s side door.
Tire Placard Location ...