Enabling And Disabling Parksense
ParkSense can be enabled and disabled with a switch located in the switch bank of the instrument panel or through the Customer-Programmable Features section of the EVIC. The available choices are: OFF, Sound Only, or Sound and Display. Refer to “Electronic Vehicle Information Center (EVIC)/Personal Settings (Customer- Programmable Features)” in “Understanding Your Instrument Panel” for further information.
When the ParkSense switch is pressed to disable the system, the instrument cluster will display the “PARK ASSIST OFF” message for approximately five seconds. Refer to “Electronic Vehicle Information Center (EVIC)” in “Understanding Your Instrument Panel” for further information. When the shift lever is moved to REVERSE and the system is disabled, the EVIC will display the “PARK ASSIST OFF” message for as long as the vehicle is in REVERSE.
The ParkSense switch LED will be ON when Park- Sense is disabled or defective. The ParkSense switch LED will be OFF when the system is enabled.
See also:
Tire Chains
Tire chains may be installed on all models except the Sahara and Rubicon. Install
chains on rear tires only.
Follow these recommendations to guard against damage and excessive tire and chain
wear ...
Dual Top — If Equipped
If your vehicle is equipped with a Dual Top, you must remove one of the tops
from the vehicle. If the soft top is removed, the pivot brackets must also be removed
from the sport bar. The soft top ...
Delete Uconnect™ Phone Paired Mobile Phones
• Press the button to begin.
• After the “Ready” prompt and the following beep, say “Setup Phone Pairing”.
• At the next prompt, say “Delete” and follow the prompts.
• You can ...