Normal Starting

NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accelerator pedal.

Turn the ignition switch to the START position and release when the engine starts. If the engine fails to start within 10 seconds, turn the ignition switch to the LOCK position, wait 10 to 15 seconds, then repeat the “Normal Starting” procedure.

Tip Start Feature

Turn the ignition switch to START position and release it as soon as the starter engages. The starter motor will continue to run, but will automatically disengage itself when the engine is running. If the engine fails to start, the starter will disengage automatically in 10 seconds. If this occurs, turn the ignition switch to the LOCK position, wait 10 to 15 seconds, then repeat the “Normal Starting” procedure.

    See also:

    Fold And Tumble Rear Seat — Two-Door Models
    NOTE: • Prior to folding the rear seat, it may be necessary to reposition the front seats. • Be sure that the front seats are fully upright and positioned forward. This will allow the rear sea ...

    In Canada
    If you believe that your vehicle has a safety defect, you should contact the Customer Service Department immediately. Canadian customers who wish to report a safety defect to the Canadian governm ...

    Commands
    The Voice Command system understands two types of commands. Universal commands are available at all times. Local commands are available if the supported radio mode is active. ...