Transfer Case Position Indicator Lights
The four-wheel drive indicator lights (4WD and 4 LOW) are located in the instrument cluster. The NEUTRAL indicator light is located on the transfer case switch. If there is no indicator light on or flashing, the transfer case position is two-wheel drive (2WD). If the indicator light is on, the desired position (4WD LOCK, 4WD LOW, or NEUTRAL) has been obtained.
If One Or More Shift Requirements Are Not Met:
• An indicator light will flash.
• The transfer case will not shift.
NOTE: The “SERV 4WD Warning Light” monitors the electric shift four-wheel drive system. If this light remains on after engine start up, or it illuminates during driving, it means that the four-wheel drive system is not functioning properly and that service is required.
See also:
Engine Block Heater — If Equipped
The engine block heater warms the engine, and permits quicker starts in cold
weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a
grounded, three-wire extension cord.
...
Two-Wheel Drive Models
The manufacturer recommends towing your vehicle with
all four wheels OFF the ground using a flatbed.
If flatbed equipment is not available, and the transmission
is operable, the vehicle may be to ...
Engine Break-In Recommendations
A long break-in period is not required for the engine and drivetrain (transmission
and axle) in your vehicle.
Drive moderately during the first 500 miles (800 km).
After the initial 60 miles (100 ...