Base System

The Tire Pressure Monitor System (TPMS) uses wireless technology with wheel rim mounted electronic sensors to monitor tire pressure levels. Sensors, mounted to each wheel as part of the valve stem, transmit tire pressure readings to the receiver module.

NOTE: It is particularly important for you to check the tire pressure in all of the tires on your vehicle monthly and to maintain the proper pressure.

The TPMS consists of the following components:
• Receiver Module
• Four Tire Pressure Monitoring Sensors
• Tire Pressure Monitoring Telltale Light

The matching full-size spare wheel and tire assembly (if equipped) has a tire pressure monitoring sensor. The matching full-size spare can be used in place of any of the four road tires. The TPMS will only monitor the pressure in the full-size spare when it is used in place of a road tire. Otherwise, a spare with a pressure below the lowpressure limit will not cause the “Tire Pressure Monitoring Telltale Light” to illuminate or the chime to sound.

See also:

Programming Additional Transmitters
Programming Key Fobs or RKE transmitters may be performed at an authorized dealer. ...

1997 Jeep Wrangler review
A two-inch layer of ice is covering Hades this morning. Must be, because a few years ago after driving a Jeep Wrangler and commenting that even Mother Teresa would find fault with this vehicle, Ch ...

Cleaning The Parksense System
Clean the ParkSense sensors with water, car wash soap and a soft cloth. Do not use rough or hard cloths. Do not scratch or poke the sensors. Otherwise, you could damage the sensors. ...