Front Fog Lamp

1. Open the hood.

2. Reach behind the headlamp housing to access the bulb.

3. Rotate the bulb’s socket counterclockwise, and remove the bulb and socket assembly from the fog lamp housing.

4. Pull the bulb out of the socket and insert the replacement bulb.

CAUTION!
Do not touch the new bulb with your fingers. Oil contamination will severely shorten bulb life. If the bulb comes in contact with any oily surface, clean the bulb with rubbing alcohol.

5. Install the bulb and socket assembly into the into the fog lamp housing, and rotate the connector clockwise to lock it in place.

6. Close the hood.

    See also:

    Automatic Unlock Doors On Exit Programming
    The “Automatic Unlock Doors On Exit” feature can be enabled or disabled as follows: 1. Close all doors and place the key in the ignition. 2. Cycle the ignition switch between LOCK and ON/ RUN an ...

    Electronic Sway Bar Disconnect — If Equipped
    Your vehicle may be equipped with an electronic disconnecting stabilizer/sway bar. This system allows greater front suspension travel in off-road situations. This system is controlled by the SWAY B ...

    Full Size Spare – If Equipped
    The full size spare is for temporary emergency use only. This tire may look like the original equipped tire on the front or rear axle of your vehicle, but it is not. This spare tire may have limi ...