Replacement Keys
NOTE: Only Key Fobs that are programmed to the vehicle electronics can be used to start and operate the vehicle. Once a Key Fob is programmed to a vehicle, it cannot be programmed to any other vehicle.
CAUTION!
• Always remove the Key Fobs from the vehicle and
lock all doors when leaving the vehicle unattended.
• With Keyless Enter-N-Go, always remember to place the ignition in OFF.
At the time of purchase, the original owner is provided with a four-digit Personal Identification Number (PIN).
Keep the PIN in a secure location. This number is required for authorized dealer replacement of Key Fobs.
Duplication of Key Fobs may be performed at an authorized dealer, this procedure consists of programming a blank Key Fob to the vehicle electronics. Ablank Key Fob is one that has never been programmed.
NOTE: When having the Sentry Key Immobilizer system serviced, bring all vehicle Key Fobs with you to the authorized dealer.
See also:
Shift Positions
The transfer case switch is located on the center console
next to the shift lever.
Transfer Case Switch
2WD
Rear Wheel Drive High Range - This range is for normal
street and highway driving o ...
Advanced Front Air Bag And Knee Bolster Locations
Advanced Front Air Bag And Knee Bolster Locations
1 — Driver And Passenger Advanced Front Air Bags
2 — Knee Bolster
NOTE: These air bags are certified to the new Federal regulations for Advan ...
Carbon Monoxide Warnings
WARNING!
Carbon monoxide (CO) in exhaust gases is deadly.
Follow the precautions below to prevent carbon
monoxide poisoning.
• Do not inhale exhaust gases. They contain carbon
monoxide, a co ...


