Power-Up

After switching the ignition key from OFF to either the ON or ACC position, or after a language change, you must wait at least fifteen seconds prior to using the system.

General Information

    See also:

    To Set A Desired ACC Speed
    When the vehicle reaches the speed desired, push the SET - button and release. The EVIC will display the set speed. ACC Set Remove your foot from the accelerator pedal. If you do not, the ve ...

    Driver’s Power Seat — If Equipped
    The power seat switch is located on the outboard side of the seat near the floor. Use this switch to move the seat up or down, forward or rearward or to tilt the seat. Power Seat Switch Adjust ...

    Operating Information And Precautions
    The Command-Trac II transfer case provides four positions: • Two–wheel drive (2WD) high range • Four-wheel drive (4WD LOCK) high range • Four-wheel drive (4WD LOW) low range • Neutra ...