To Resume Speed

To resume a previously set speed, push the RES (+) button and release. Resume can be used at any speed above 20 mph (32 km/h).

    See also:

    2011 Jeep Wrangler review
    If the Donner Party had Jeeps, they never would have found themselves on the menu. Jeeps can eat up just about any trail. During a recent rock crawl through Utah, the state where the actual Donn ...

    Adding Washer Fluid
    The fluid reservoir for the windshield washers and the rear window washer (if equipped) is shared. The fluid reservoir is located in the engine compartment. Be sure to check the fluid level at reg ...

    Rain Sensing Intermittent Wipers — If Equipped
    When ON is selected, the system will automatically activate the windshield wipers if it senses moisture on the windshield. To make your selection, press and release the SELECT button until “ON ...