Uconnect™ Phone Button

The radio or steering wheel controls (if equipped) will contain the two control
buttons (Uconnect™ Phone
button and
Voice Command
button) that will enable
you to access the system. When you press the button you will hear the word Uconnect™
followed by a BEEP. The beep is your signal to give a command.
NOTE: The driver side upper windshield trim contains the microphone for the Uconnect™ Phone.
See also:
Air Bag Warning Light
The light should come on and remain on for four to eight
seconds as a bulb check when the ignition switch is first
turned ON. If the light is not lit during starting, see your
authorized dealer. ...
Operating Instructions - Uconnect™ Multimedia (Satellite) Mode
NOTE: The ignition switch must be in the ON/RUN or
ACC position to operate the radio.
SEEK Buttons
Press and release the SEEK buttons to search for the next
channel in Satellite mode. Press the ...
Preparations For Jacking
1. Park the vehicle on a firm level surface as far from the
edge of the roadway as possible. Avoid icy or slippery
areas.
WARNING!
Do not attempt to change a tire on the side of the
vehicle c ...


