Call by Saying a Name

• Press the • After the “Ready” prompt and the following beep, say “Call”. button to begin.

• After the “Ready” prompt and the following beep, say “Call”.

• The system will prompt you to say the name of the person you want to call.

• After the “Ready” prompt and the following beep, say the name of the person you want to call. For example, you can say “John Doe”, where John Doe is a previously stored name entry in the Uconnect™ phonebook or downloaded phonebook. To learn how to store a name in the phonebook, refer to “Add Names to Your Uconnect™ Phonebook”, in the phonebook.

• The Uconnect™ system will confirm the name and then dial the corresponding phone number, which may appear in the display of certain radios.

    See also:

    Electronic Volume Control
    The electronic volume control turns continuously (360 degrees) in either direction without stopping. Turning the ON/VOLUME control knob to the right increases the volume and to the left decreases ...

    Using The Remote Control
    1. Press the MODE button on the Remote Control. 2. While looking at the video screen, highlight DISC by either pressing Up/Down/Left/Right buttons or by repeatedly pressing the MODE button, then ...

    To Arm The System
    1. Remove the key from the ignition switch and exit the vehicle. 2. Lock the doors and liftgate by pressing the power door LOCK switch or the LOCK button on the Remote Keyless Entry (RKE) trans ...