Call Termination

To end a call in progress, momentarily press the be terminated and if there is a call on hold, it will become the new active call. button. Only the active call(s) will be terminated and if there is a call on hold, it will become the new active call.

If the active call is terminated by the phone far end, a call on hold may not become active automatically. This is cell phone-dependent. To bring the call back from hold, press and hold the until you hear a single beep. button until you hear a single beep.

    See also:

    Operating Instructions - Radio Mode
    NOTE: The ignition switch must be in the ON or ACC position to operate the radio. Power Switch/Volume Control (Rotary) Push the ON/VOLUME control knob to turn on the radio. Press the ON/VOLUME c ...

    Jump-Starting Procedures
    If your vehicle has a discharged battery it can be jumpstarted using a set of jumper cables and a battery in another vehicle or by using a portable battery booster pack. Jump-starting can be dan ...

    To Exit Remote Start Mode And Drive The Vehicle
    Before the end of 15 minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, prior to the end of t ...