List Paired Mobile Phone Names

• Press the • After the “Ready” prompt and the following beep, say “Setup Phone Pairing”. button to begin.

• After the “Ready” prompt and the following beep, say “Setup Phone Pairing”.

• When prompted, say “List Phones”.

• The Uconnect™ Phone will play the phone names of all paired mobile phones in order from the highest to the lowest priority. To “Select” or “Delete” a paired phone being announced, press the and say “Select” or “Delete”. Also, see the next two sections for an alternate way button and say “Select” or “Delete”. Also, see the next two sections for an alternate way to “Select” or “Delete” a paired phone.

    See also:

    Maintenance-Free Battery
    Your vehicle is equipped with a maintenance-free battery. You will never have to add water, nor is periodic maintenance required. WARNING! • Battery fluid is a corrosive acid solution and can ...

    Before You Begin Programming HomeLink
    Be sure that your vehicle is parked outside of the garage before you begin programming. For more efficient programming and accurate transmission of the radio-frequency signal it is recommended th ...

    Programming A Non-Rolling Code
    For programming Garage Door Openers manufactured before 1995. 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink ...