To Accelerate For Passing
Press the accelerator as you would normally. When the pedal is released, the vehicle will return to the set speed.
Using Electronic Speed Control On Hills
The transmission may downshift on hills to maintain the vehicle set speed.
NOTE: The Electronic Speed Control system maintains speed up and down hills. A slight speed change on moderate hills is normal.
On steep hills, a greater speed loss or gain may occur so it may be preferable to drive without Electronic Speed Control.
WARNING!
Electronic Speed Control can be dangerous where the system cannot maintain a constant
speed. Your vehicle could go too fast for the conditions, and you could lose control
and have an accident. Do not use Electronic Speed Control in heavy traffic or on
roads that are winding, icy, snow-covered or slippery.
See also:
Key-In-Ignition Reminder
Opening the driver’s door when the key is in the ignition sounds a signal to
remind you to remove the key.
NOTE: The Key-In-Ignition reminder only sounds when the ignition key is placed
in the ...
Spare Tire Matching Original Equipped Tire And Wheel – If Equipped
Your vehicle may be equivalent with a spare tire and
wheel in look and function as the original equipment tire
and wheel found on the front or rear axle of your vehicle.
This spare tire may be us ...
Jump-Starting Procedures
If your vehicle has a discharged battery it can be jumpstarted using a set of
jumper cables and a battery in another vehicle or by using a portable battery booster
pack. Jump-starting can be dange ...


