Play Mode

When switched to iPod /USB/MP3 control mode, the iPod or external USB device automatically starts Play mode. In Play mode, the following buttons on the radio faceplate may be used to control the iPod or external USB device and display data:

• Use the TUNE control knob to select the next or previous track.

• Turning it clockwise (forward) by one click, while playing a track, skips to the next track or press the VR button and say Next Track .

• Turning it counterclockwise (backward) by one click, will jump to the previous track in the list or press the VR button and say Previous Track .

• Jump backward in the current track by pressing and holding the << RW button. Holding the << RW button long enough will jump to the beginning of the current track.

• Jump forward in the current track by pressing and holding the FF >> button.

• A single press backward << RW or forward FF >> will jump backward or forward respectively, for five seconds.

• Use the << SEEK and SEEK >> buttons to jump to the previous or next track. Pressing the SEEK >> button during play mode will jump to the next track in the list, or press the VR button and say Next or Previous Track .

• While a track is playing, press the INFO button to see the associated metadata (artist, track title, album, etc.) for that track. Pressing the INFO button again jumps to the next screen of data for that track. Once all screens have been viewed, the last INFO button press will go back to the play mode screen on the radio.

• Pressing the REPEAT button will change the audio device mode to repeat the current playing track or press the VR button and say Repeat ON or Repeat Off .

• Press the SCAN button to use iPod /USB/MP3 device scan mode, which will play the first 10 seconds of each track in the current list and then forward to the next song. To stop SCAN mode and start playing the desired track, when it is playing the track, press the SCAN button again. During Scan mode, pressing the << SEEK and SEEK >> buttons will select the previous and next tracks.

• RND button (available on sales code RES radio only):

Pressing this button toggles between Shuffle ON and Shuffle OFF modes for the iPod or external USB device, or press the VR button and say Shuffle ON or Shuffle Off . If the RND icon is showing on the radio display, then the shuffle mode is ON.

    See also:

    Jeep Grand Cherokee review
    The following is a true story: While trying to access the lower Latch anchors in the 2011 Jeep Grand Cherokee, my favorite sunglasses fell off my head and onto the ground; in the heat of my effort ...

    Shift Positions
    The transfer case switch is located on the center console next to the shift lever. Transfer Case Switch 2WD Rear Wheel Drive High Range - This range is used for normal street and highway driv ...

    List Or Browse Mode
    During Play mode, pressing any of the buttons described below, will bring up List mode. List mode enables scrolling through the list of menus and tracks on the audio device. • TUNE control kn ...