Automatic Unlock Doors On Exit Programming
The Automatic Unlock Doors On Exit feature can be enabled or disabled as follows:
• For vehicles equipped with the Electronic Vehicle Information Center (EVIC), refer to “Electronic Vehicle Information Center (EVIC)/Personal Settings (Customer- Programmable Features)” in “Understanding Your Instrument Panel” for further information.
• For vehicles not equipped with the EVIC, perform the following procedure:
1. Close all doors and place the key in the ignition.
2. Cycle the ignition switch between OFF and ON/RUN and then back to OFF five times, ending up in the ON/RUN position.
3. Press the power door UNLOCK switch to unlock the doors.
4. A single chime will indicate the completion of the programming.
Repeat these steps if you want to return this feature to its previous setting.
NOTE: Use the Automatic Unlock Doors On Exit feature in accordance with local laws.
See also:
EVIC Units Selection (Units In Display)
Displays the units used for the Outside Temperature,
Average Fuel Economy, Distance to Empty and Tire
Pressure features. Press and release the SELECT button to
toggle units between U.S. and METR ...
Customer Key Programming
If you have two valid Sentry Keys , you can program new Sentry Keys to the system
by performing the following procedure:
1. Cut the additional Sentry Key Transponder blank(s) to match the ignition ...
Outside Mirrors
To receive maximum benefit, adjust the outside mirror(s) to center on the adjacent
lane of traffic with a slight overlap of the view obtained on the inside mirror.
Outside Rearview Mirror
WARNIN ...