Memory Position Recall

NOTE:
• For vehicles equipped with an automatic transmission, the vehicle must be in PARK to recall memory positions.

If a recall is attempted when the vehicle is not in PARK, a message will display in the EVIC, if equipped.

• For vehicles equipped with a manual transmission, the vehicle speed must be at 0 mph (0 km/h) to recall memory positions. If a recall is attempted with the vehicle speed above 0 mph (0 km/h), a message will display in the EVIC, if equipped.

To recall the memory settings for driver one, press MEMORY button number 1 or the UNLOCK button on the RKE transmitter linked to memory position 1.

To recall the memory setting for driver two, press MEMORY button number 2 or the UNLOCK button on the RKE transmitter linked to memory position 2.

A recall can be cancelled by pressing any of the MEMORY buttons (S, 1, or 2) during a recall. When a recall is cancelled, the driver seat will stop moving. A delay of one second will occur before another recall can be selected.

    See also:

    Electronic Speed Control – If Equipped
    − Do not use in hilly terrain or with heavy loads. − When using the speed control, if you experience speed drops greater than 10 mph (16 km/h), disengage until you can get back to cru ...

    To Unlock The Doors
    Press and release the UNLOCK button on the RKE transmitter once to unlock the driver’s door or twice to unlock all doors. The turn signal lamps will flash to acknowledge the unlock signal. The ...

    Operating Instructions — Radio Mode
    NOTE: The ignition switch must be in the ON/RUN or ACC position to operate the radio. ...