Tire Chains

Use only compact chains, or other traction aids that meet SAE type “Class S” specifications. Chains must be the proper size for the vehicle, as recommended by the chain manufacturer. In addition, only install tire chains of the rear tires with P225/75R16 or smaller tires.

CAUTION!
To avoid damage to your vehicle, tires, or chains, observe the following precautions:

• Do not use tire chains on vehicles equipped with tires other than P225/75R16 or smaller tires. There may not be adequate clearance for the chains and you are risking structural or body damage to your vehicle.

• Because of limited chain clearance between tires and other suspension components, it is important that only chains in good condition are used. Broken chains can cause serious vehicle damage. Stop the vehicle immediately if noise occurs that could suggest chain breakage. Remove the damaged parts of the chain before further use.

• Install chains on the rear wheels as tightly as possible and then retighten after driving about 1⁄2 mile (0.8 km).

• Do not exceed 45 mph (72 km/h).

• Drive cautiously and avoid severe turns and large bumps, especially with a loaded vehicle.

• Use on Rear Wheels only.

• Do not drive for a prolonged period on dry pavement.

• Observe the tire chain manufacturer’s instructions on method of installation, operating speed, and conditions for use. Always use the lower suggested operating speed of the chain manufacturer if different from the speed recommended by the manufacturer.

These cautions apply to all chain traction devices, including link and cable (radial) chains.

    See also:

    Seat Belt Pretensioners
    The seat belts for both front seating positions are equipped with pretensioning devices that are designed to remove slack from the seat belt in the event of an accident. These devices may improve ...

    Selecting Uconnect™ Multimedia (Satellite) Mode
    Press the SAT button until SAT appears in the display.A CD may remain in the radio while in the Satellite radio mode. ...

    Operating Instructions - Uconnect™ Multimedia (Satellite) Mode
    NOTE: The ignition switch must be in the ON/RUN or ACC position to operate the radio. SEEK Buttons Press and release the SEEK buttons to search for the next channel in Satellite mode. Press the ...