To Enter Remote Start
Press and release the REMOTE START button on the RKE transmitter twice within five seconds.
The parking lights will flash and the horn will chirp twice (if programmed). Then, the engine will start and the vehicle will remain in the Remote Start mode for a 15-minute cycle.
NOTE:
• The park lamps will turn on and remain on during Remote Start mode.
• For security, power window operation is disabled when the vehicle is in the Remote Start mode.
• The engine can be started two consecutive times (two 15-minute cycles) with the RKE transmitter. However, the ignition switch must be cycled to the ON/RUN position before you can repeat the start sequence for a third cycle.
Remote start will also cancel if any of the following occur:
• The engine stalls or RPM exceeds 2500
• Any engine warning lamps come on
• The hood is opened
• The hazard switch is pressed
• The transmission is moved out of PARK
• The brake pedal is pressed
See also:
Engineering
Jeep Wrangler delivers unmatched off-road capability with legendary
four-wheel drive and is produced with more than seven decades of 4x4 engineering
experience behind it. Wrangler continues to off ...
Replacement Tires
The tires on your new vehicle provide a balance of many characteristics. They
should be inspected regularly for wear and correct cold tire inflation pressure.
The manufacturer strongly recommends ...
ACC Unavailable Warning
If the system turns off, and the EVIC displays “ACC/
FCW Unavailable, Vehicle System Error”, there may be a
temporary malfunction that limits ACC functionality.
Although the vehicle is still ...