Automatic Unlock Doors On Exit Programming
The “Automatic Unlock Doors On Exit” feature can be enabled or disabled as follows:
1. Close all doors and place the key in the ignition.
2. Cycle the ignition switch between LOCK and ON/ RUN and then back to LOCK four times ending up in the LOCK position.
3. Press the power door unlock switch to unlock the doors.
4. A single chime will indicate the completion of the programming.
5. Repeat these steps if you want to return this feature to its previous setting.
NOTE: Use the “Automatic Unlock Doors On Exit” feature in accordance with local laws.
See also:
60/40 Split Folding Rear Seat — Four-Door Models
To provide additional storage area, each rear seat can be folded flat to allow
for extended cargo space and still maintain some rear seating room.
NOTE:
• Prior to folding the rear seat, it may ...
Power Inverter — If Equipped
There is a 115 Volt, 150Watt inverter outlet located on the
back of the center console to convert DC current to AC
current. This outlet can power cellular phones, electronics
and other low power ...
iPod /USB/MP3 Control — If Equipped
NOTE: This section is for sales code RES and REQ/ REL/RET radios only with
Uconnect™. For sales code RBZ/RHB, RHR, RHP, RHW or RB2 touch-screen radio iPod
/USB/MP3 control feature, refer to the ...