SET Button – To Set the Pushbutton Memory
When you are receiving a channel that you wish to commit to pushbutton memory, press the SET button.
The symbol SET 1 will now show in the display window.
Select the button (1-6) you wish to lock onto this channel and press and release that button. If a button is not selected within five seconds after pressing the SET button, the channel will continue to play but will not be stored into pushbutton memory.
You may add a second channel to each pushbutton by repeating the above procedure with this exception: Press the SET button twice and SET 2 will show in the display window. Each button can be set for SET 1 and SET 2. This allows a total of 12 Satellite channels to be stored into pushbutton memory. The channels stored in SET 2 memory can be selected by pressing the pushbutton twice.
Every time a preset button is used, a corresponding button number will display.
See also:
Reset
• press the button.
• After the “Ready” prompt, and the following beep, say “Setup”, then “Reset”.
This will delete all phone pairing, phone book entries, and other settings in
al ...
Selection Of Lubricant
Use only manufacturer’s recommended fluid. Refer to “Fluids, Lubricants, and
Genuine Parts” in “Maintaining Your Vehicle” for further information. ...
Going & Stopping
The Liberty may have gotten all-new sheet metal and a different interior, but
its engine is exactly the same. The 210-horsepower V-6 is completely adequate,
especially at highway cruising speeds. ...