Clock Setting Procedure :: Operating Instructions — Radio Mode :: Media Center 130 (Sales Code RES) :: Understanding Your Instrument Panel :: Jeep Wrangler Owner's Manual :: Jeep Wrangler - JeepManuals.org

Clock Setting Procedure

Jeep Wrangler / Jeep Wrangler Owner's Manual / Understanding Your Instrument Panel / Media Center 130 (Sales Code RES) / Operating Instructions — Radio Mode / Clock Setting Procedure

1. Press and hold the TIME button until the hours blink.

2. Adjust the hours by turning the right side TUNE/ SCROLL control knob.

3. After adjusting the hours, press the right side TUNE/ SCROLL control knob to set the minutes. The minutes will begin to blink.

4. Adjust the minutes using the right side TUNE/ SCROLL control knob. Press the TUNE/SCROLL control knob to save time change.

5. To exit, press any button/knob, or wait five seconds.

See also:

Jacking And Tire Changing
WARNING! • Do not attempt to change a tire on the side of the vehicle close to moving traffic. Pull far enough off the road to avoid the danger of being hit when operating the jack or changi ...

Supplemental Active Head Restraints (AHR)
These head restraints are passive, deployable components, and vehicles with this equipment cannot be readily identified by any markings, only through visual inspection of the head restraint. The ...

Power Switch/Volume Control (Rotary)
Push the ON/VOLUME control knob to turn on the radio. Push the ON/VOLUME control knob a second time to turn off the radio. ...