Automatic Transmission – If Equipped
Jeep Wrangler / Jeep Wrangler Owner's Manual / Starting And Operating / Starting Procedures / Automatic Transmission – If Equipped
Start the vehicle with the shift lever in the PARK position (vehicle can also be started in NEUTRAL). Apply the brake before shifting to any driving range.
See also:
Ignition Off Operation
The power sunroof switches can be programmed to
remain active for up to approximately ten minutes after
the ignition switch has been turned OFF. Refer to “Electronic
Vehicle Information Center ...
Adding Fluid
Fluid should be added only at filler hole until fluid begins to run out of the
hole. ...
ESN/SID Access
With the ignition switch in the ON/RUN or ACC position and the radio on, press
the SETUP button and scroll using the TUNE/SCROLL control knob until Sirius ID is
selected. Press the TUNE/SCROLL con ...


