Brake Master Cylinder
The fluid level in the master cylinders should be checked whenever the vehicle is serviced. If necessary, add fluid to bring level to the full level mark on the side of the reservoir of the brake master cylinder. With disc brakes, fluid level can be expected to fall as the brake pads wear.
If the brake fluid level is abnormally low, check system for leaks.
Refer to “Fluids, Lubricants, and Genuine Parts” in “Maintaining Your Vehicle” for further information.
WARNING!
• Use only manufacturer’s recommended brake fluid. Refer to “Fluids, Lubricants,
and Genuine Parts” in “Maintaining Your Vehicle” for further information. Using
the wrong type of brake fluid can severely damage your brake system and/or impair
its performance. The proper type of brake fluid for your vehicle is also identified
on the original factory installed hydraulic master cylinder reservoir.
• To avoid contamination from foreign matter or moisture, use only new brake fluid or fluid that has been in a tightly closed container. Keep the master cylinder reservoir cap secured at all times.
Brake fluid in a open container absorbs moisture from the air resulting in a lower boiling point.
This may cause it to boil unexpectedly during hard or prolonged braking, resulting in sudden brake failure. This could result in a collision.
• Overfilling the brake fluid reservoir can result in spilling brake fluid on hot engine parts, causing the brake fluid to catch fire. Brake fluid can also damage painted and vinyl surfaces, care should be taken to avoid its contact with these surfaces.
• Do not allow petroleum based fluid to contaminate the brake fluid. Brake seal components could be damaged, causing partial or complete brake failure. This could result in a collision.
See also:
How To Use Remote Start
All of the following conditions must be met before the
engine will remote start:
• Shift lever in PARK
• Doors closed
• Hood closed
• Liftgate/Flipper Glass closed
• Hazard switc ...
Recent Calls
If your phone supports “Automatic Phonebook Download”, Uconnect™ Phone can list
your Outgoing, Incoming and Missed Calls. ...
Delete/Erase “All” Uconnect™ Phonebook Entries
• Press the button to begin.
• After the “Ready” prompt and the following beep, say “Phonebook Erase All”.
• The Uconnect™ Phone will ask you to verify that you wish to delete all t ...


