Linking And Unlinking The Remote Keyless Entry Transmitter To Memory
Your Remote Keyless Entry (RKE) transmitters can be programmed to recall one of two pre-programmed memory profiles with a press of the UNLOCK button on the RKE transmitter.
To program your RKE transmitters, perform the following:
1. Remove the key from the ignition.
2. Select the desired memory profile 1 or 2.
3. Press and release the SET button on the memory switch, then within five seconds press and release the side of the rocker switch labeled 1 or 2 accordingly.
Memory Profile Set” (1 or 2) will display in the EVIC, if equipped.
4. Press and release the LOCK button on the RKE transmitter within 10 seconds.
NOTE: Your RKE transmitters can be unlinked to the memory setting by pressing the SET button followed by the UNLOCK button on the RKE transmitter in Step 4 above.
See also:
Safety and Security
The 2008 Jeep Liberty has a full range of active and passive safety systems.
Among the vehicle's standard equipment are Electronic Stability Program,
Electronic Roll Mitigation, All-speed Traction ...
Front Cupholders
The front cupholders are located in the center console.
Front Cupholders ...
Service The Parksense Rear Park Assist System
When the ParkSense Rear Park Assist System is malfunctioning,
the instrument cluster will actuate a single
chime, once per ignition cycle, and it will display the
“CLEAN PARK ASSIST SENSORS” ...


