Accessing The Storage Bin

NOTE: The spring-loaded latches that retain the storage bin cover to the cargo load floor should not be used as cargo tie-downs.

1. Flip the spring-loaded latch pull-loops up.

Cargo Load Floor Loops
Cargo Load Floor Loops

2. Pull the loops upward and twist them one-quarter turn so that they are parallel to the slots in the storage bin cover.

3. Lift the cover upward over the loops.

4. Turn over the cover and reinstall it.

NOTE: You can install the cover with either side facing upward.

5. With the cover seated in the floor, pull upward on loops and twist them one-quarter turn so that they are no longer parallel to the slots in the cover.

6. Flip the loops down.

WARNING!
A loose storage bin cover thrown forward in a accident or hard stop could endanger the occupants of the vehicle. Always latch the storage bin cover to the cargo load floor with the spring-loaded latches when not accessing the storage bin.

    See also:

    Blind Spot Monitoring — If Equipped
    The Blind Spot Monitoring (BSM) system uses two radarbased sensors, located inside the rear bumper fascia, to detect highway licensable vehicles (automobiles, trucks, motorcycles, etc.) that ent ...

    Call By Saying A Name
    • Press the button to begin. • After the “Ready” prompt and the following beep, say “Call”. • The system will prompt you to say the name of the person you want to call. • After ...

    Redial
    • Press the button to begin. • After the “Ready” prompt and the following beep, say “Redial”. • The Uconnect™ Phone will call the last number that was dialed from your mobile ph ...