See also:

Programming A Non-Rolling Code
For programming Garage Door Openers manufactured before 1995. 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink ...

Closing The Sunrider
Perform the above steps in the opposite order. NOTE: Failure to fold the fabric rearward will allow the material to sag and may block the rearview mirror. ...

To Vary The Speed Setting
When the Electronic Speed Control is set, you can increase speed by pushing the RES (+) button. If the button is continually pressed, the set speed will continue to increase until the button is ...