Appearance Care And Protection From Corrosion

See also:

Customer Key Programming
If you have two valid Sentry Keys , you can program new Sentry Keys to the system by performing the following procedure: 1. Cut the additional Sentry Key Transponder blank(s) to match the ignit ...

Automatic Unlock Doors On Exit Programming
The “Automatic Unlock Doors On Exit” feature can be enabled or disabled as follows: 1. Close all doors and place the key in the ignition. 2. Cycle the ignition switch between LOCK and ON/ RUN an ...

Raising The Soft Top
1. Unclip and move the sun visors to the side. 2. Install door frames, if removed. Refer to “Door Frame” in this section for further information. 3. Make sure the plastic sleeve is slid over S ...