Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) — If Equipped

Jeep Wrangler / Jeep Wrangler Owner's Manual / Things To Know Before Starting Your Vehicle / Remote Starting System — If Equipped / How To Use Remote Start / Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) — If Equipped

The following messages will display in the EVIC if the vehicle fails to remote start or exits remote start prematurely:

• Remote Start Aborted — Door Ajar
• Remote Start Aborted — Hood Ajar
• Remote Start Aborted — Fuel Low
• Remote Start Aborted — L/Gate Ajar
• Remote Start Aborted — System Fault

The EVIC message stays active until the ignition is turned to the ON/RUN position.

    See also:

    Wiper Mode — If Equipped
    When this feature is selected, the system will automatically activate the windshield wipers if it senses moisture on the windshield. To make your selection, press and release the SELECT button u ...

    Electronic Speed Control — If Equipped
    When engaged, the Electronic Speed Control takes over accelerator operations at speeds greater than 25 mph (40 km/h). The Electronic Speed Control buttons are located on the right side of the s ...

    Limited-Use Spare – If Equipped
    The limited-use spare tire is for temporary emergency use only. This tire is identified by a label located on the limited-use spare wheel. This label contains the driving limitations for this sp ...