To Exit Remote Start Mode And Drive The Vehicle
Before the end of the 15-minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, insert the key into the ignition switch and turn the switch to the ON/RUN position.
NOTE: The ignition switch must be in the ON/RUN position in order to drive the vehicle.
See also:
SAFETY
The Wrangler Unlimited has two sets of lower Latch anchors in the outboard
seats. The outer Latch anchors were easy to use, but the inner anchors in both
positions sat right behind the seat belt b ...
Front Heated Seats
There are two heated seat switches that allow the driver
and passenger to operate the seats independently. The
controls for each heater are located near the bottom
center of the instrument panel ...
Recreational Towing – Quadra–Trac II / Quadra–Drive II Four-Wheel Drive Models
.
The transfer case must be shifted into NEUTRAL (N) and
the transmission must be placed in PARK for recreational
towing. The NEUTRAL (N) selection button is adjacent to
the transfer case selector ...


