Automatic Unlock Doors On Exit Programming
The “Automatic Unlock Doors On Exit” feature can be enabled or disabled as follows:
1. Close all doors and place the key in the ignition.
2. Cycle the ignition switch between LOCK and ON/ RUN and then back to LOCK four times ending up in the LOCK position.
3. Press the power door unlock switch to unlock the doors.
4. A single chime will indicate the completion of the programming.
5. Repeat these steps if you want to return this feature to its previous setting.
NOTE: Use the “Automatic Unlock Doors On Exit” feature in accordance with local laws.
See also:
The Inside
Unfortunately, off-roading is important only to a minority, even among Jeep
buyers, which doesn't make for much of a competitive advantage in the real
world. What's important to the majority is a ...
Gross Axle Weight Rating (GAWR)
The GAWR is the maximum permissible load on the front and rear axles. The load
must be distributed in the cargo area so that the GAWR of each axle is not exceeded.
Each axle’s GAWR is determined ...
Operating Instructions (Voice Command System) — If Equipped
Refer to “Voice Command” in the Uconnect™ User
Manual located on the DVD for further details. ...


