Place/Retrieve a Call From Hold

To put a call on hold, press the button until you hear a single beep. This indicates that the call is on hold. To button until you hear a single beep. This indicates that the call is on hold. To bring the call back from hold, press and hold the Toggling Between Calls button until you hear a single beep.

    See also:

    Troubleshooting Tips
    If you are having trouble programming HomeLink , here are some of the most common solutions: • Replace the battery in the original hand-held transmitter. • Press the LEARN button on the Garage ...

    Operating Instructions - Uconnect™ Multimedia (Satellite) Mode
    NOTE: The ignition switch must be in the ON/RUN or ACC position to operate the radio. SEEK Buttons Press and release the SEEK buttons to search for the next channel in Satellite mode. Press the ...

    To Exit Remote Start Mode Without Driving The Vehicle
    Press and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle. NOTE: To avoid unintentional shut downs, the system will disable the one-time press o ...