Dual Top — If Equipped
If your vehicle is equipped with a Dual Top, you must remove one of the tops from the vehicle. If the soft top is removed, the pivot brackets must also be removed from the sport bar. The soft top was installed at the factory for shipping purposes only. The soft top and the hard top are to be used independently. Removal is mandatory to prevent any possible wear and tear on the soft top. Your vehicle warranty will not cover damage resulting from both tops remaining on the vehicle at the same time for extended periods of time.
See also:
Front Panel(s) Installation With Rear Hard Top Removed
1. Turn the left and right panels over and move the spacer block (located on
the rear of the panel) upward 90 degrees.
NOTE: The front panel(s) must be positioned properly to ensure sealing. Set ...
Traction Grades
The Traction grades, from highest to lowest, are AA, A, B,
and C. These grades represent the tire’s ability to stop on
wet pavement, as measured under controlled conditions
on specified govern ...
Display Units In
The EVIC can be changed between English and Metric
units of measure. The units apply to the Outside Temperature,
Average Fuel Economy, Distance to Empty, and
Tire Pressure displays. To make your ...