To Set The Variance

Start the engine and leave the transmission gear selector lever in the PARK position. Press and hold the RESET button on the steering wheel (for approximately ten seconds) until the current variance zone number is displayed.

To change the zone, press and release the STEP button to increase the variance one step. Repeat as necessary until the desired variance is achieved.

NOTE: The factory default zone is 8. During programming, the zone value will wrap around from zone 15 to zone 1.

    See also:

    After Driving Off-Road
    Off-road operation puts more stress on your vehicle than does most on-road driving. After going off-road, it is always a good idea to check for damage. That way you can get any problems taken ca ...

    Hill Climbing
    Hill climbing requires good judgment and a good understanding of your abilities and your vehicle’s limitations. Hills can cause serious problems. Some are just too steep to climb and should not ...

    Delete Uconnect™ Phone Paired Mobile Phones
    • Press the button to begin. • After the “Ready” prompt and the following beep, say “Setup Phone Pairing”. • At the next prompt, say “Delete” and follow the prompts. • You can ...