Clock Setting Procedure :: Operating Instructions — Radio Mode :: Media Center 130 (Sales Code RES) :: Understanding Your Instrument Panel :: Jeep Wrangler Owner's Manual :: Jeep Wrangler - JeepManuals.org

Clock Setting Procedure

Jeep Wrangler / Jeep Wrangler Owner's Manual / Understanding Your Instrument Panel / Media Center 130 (Sales Code RES) / Operating Instructions — Radio Mode / Clock Setting Procedure

1. Press and hold the TIME button until the hours blink.

2. Adjust the hours by turning the right side TUNE/ SCROLL control knob.

3. After adjusting the hours, press the right side TUNE/ SCROLL control knob to set the minutes. The minutes will begin to blink.

4. Adjust the minutes using the right side TUNE/ SCROLL control knob. Press the TUNE/SCROLL control knob to save time change.

5. To exit, press any button/knob, or wait five seconds.

See also:

Power Inverter — If Equipped
There is a 115 Volt, 150Watt inverter outlet located on the front of the center console to convert DC current to AC current. This outlet can power cellular phones, electronics and other low power ...

Supplemental Seat-Mounted Side Air Bags (SAB) — If Equipped
Supplemental Seat-Mounted Side Air Bags (SAB) may provide enhanced protection to help protect an occupant during a side impact. The SAB is marked with an air bag label sewn into the outboard side ...

ESN/SID Access
With the ignition switch in the ON/RUN or ACC position and the radio on, press the SETUP button and scroll using the TUNE/SCROLL control knob until Sirius ID is selected. Press the TUNE/SCROLL con ...