Automatic Transmission – If Equipped :: Starting Procedures :: Starting And Operating :: Jeep Wrangler Owner's Manual :: Jeep Wrangler - JeepManuals.org

Automatic Transmission – If Equipped

Jeep Wrangler / Jeep Wrangler Owner's Manual / Starting And Operating / Starting Procedures / Automatic Transmission – If Equipped

Start the vehicle with the shift lever in the PARK position (vehicle can also be started in NEUTRAL). Apply the brake before shifting to any driving range.

See also:

Road Tire Installation
1. Mount the road tire on the axle. 2. Install the remaining lug nuts with the cone shaped end of the nut toward the wheel. Lightly tighten the lug nuts. WARNING! To avoid the risk of forcing the ...

Electronic Speed Control — If Equipped
When engaged, the Electronic Speed Control takes over accelerator operations at speeds greater than 25 mph (40 km/h). The Electronic Speed Control buttons are located on the right side of the s ...

Flash-To-Pass
You can signal another vehicle with your headlights by lightly pulling the multifunction lever toward you. This will turn on the high beam headlights until the lever is released. NOTE: If the m ...