To Exit Remote Start Mode And Drive The Vehicle
Before the end of the 15-minute cycle, press and release the UNLOCK button on the RKE transmitter to unlock the doors and disarm the Vehicle Security Alarm (if equipped). Then, insert the key into the ignition switch and turn the switch to the ON/RUN position.
NOTE: The ignition switch must be in the ON/RUN position in order to drive the vehicle.
See also:
Fluid Leaks
Check area under vehicle after overnight parking for fuel, engine coolant, oil,
or other fluid leaks. Also, if gasoline fumes are detected or if fuel, power steering
fluid, or brake fluid leaks ar ...
Trailer Sway Control (TSC)
TSC uses sensors in the vehicle to recognize an excessively swaying trailer and
will take the appropriate actions to attempt to stop the sway. The system may reduce
engine power and apply the brak ...
Service TPMS Warning
When a system fault is detected, the “Tire Pressure
Monitoring Telltale Light” will flash on and off for
75 seconds and then remain on solid. The system fault
will also sound a chime. If the ...