Seat Belts

Inspect the belt system periodically, checking for cuts, frays, and loose parts. Damaged parts must be replaced immediately. Do not disassemble or modify the system.

Front seat belt assemblies must be replaced after a collision. Rear seat belt assemblies must be replaced after a collision if they have been damaged (i.e., bent retractor, torn webbing, etc.). If there is any question regarding belt or retractor condition, replace the belt.

    See also:

    Lap/Shoulder Belt Untwisting Procedure
    Use the following procedure to untwist a twisted lap/ shoulder belt. 1. Position the latch plate as close as possible to the anchor point. 2. At about 6 to 12 in (15 to 30 cm) above the latch plate, ...

    Remote Start Abort Message On Electronic Vehicle Information Center (EVIC) — If Equipped
    The following messages will display in the EVIC if the vehicle fails to remote start or exits remote start prematurely: • Remote Start Aborted — Door Ajar • Remote Start Aborted — Hood Aja ...

    Cargo Tie-Down Hooks And Loops
    The tie-downs located on cargo area floor should be used to secure loads safely when the vehicle is moving. Cargo Tie-Down Hooks Cargo Tie-Down Loops Cargo tie-down loops are located on the t ...