Uconnect™ Phone Button

The radio or steering wheel controls (if equipped) will contain the two control
buttons (Uconnect™ Phone
button and
Voice Command
button) that will enable
you to access the system. When you press the button you will hear the word Uconnect™
followed by a BEEP. The beep is your signal to give a command.
NOTE: The driver side upper windshield trim contains the microphone for the Uconnect™ Phone.
See also:
Ignition Off Operation
The power sunroof switches can be programmed to
remain active for up to approximately ten minutes after
the ignition switch has been turned OFF. Refer to “Electronic
Vehicle Information Center ...
Using The Remote Control
1. Press the MODE button on the Remote Control.
2. While looking at Screen 1, highlight DISC by either
pressing Up/Down/Left/Right buttons or by repeatedly
pressing the MODE button, then press EN ...
Synthetic Engine Oils
You may use synthetic engine oils provided the recommended
oil quality requirements are met, and the recommended
maintenance intervals for oil and filter changes
are followed. ...


