Towing Requirements – Trailer Lights And Wiring
Whenever you pull a trailer, regardless of the trailer size, stop lights and turn signals on the trailer are required for motoring safety.
The Trailer Tow Package will include a four–pin wiring harness. Use a factory-approved trailer harness and connector.
NOTE: Do not cut or splice wiring into the vehicles wiring harness.
The electrical connections are all complete to the vehicle but you must mate the harness to a trailer connector.
Refer to the following illustration.
Four-Pin Connector
1 — Female Pins
2 — Male Pin
3 — Ground
4 — Park
5 — Left Stop/Turn
6 — Right Stop/Turn
See also:
Front Seat Adjustment
The seat can be adjusted forward or rearward by using a bar located by the front
of the seat cushion, near the floor.
While sitting in the seat, lift up on the bar located under the seat cushion
...
Department Of Transportation Uniform Tire Quality Grades
The following tire grading categories were established by the National Highway
Traffic Safety Administration. The specific grade rating assigned by the tire’s
manufacturer in each category is sh ...
Occupant Classification System (OCS)
The OCS is part of a Federally regulated safety system
required for this vehicle. It is designed to turn off the
passenger Advanced Front Air Bag for an empty seat and
for occupants classified i ...