Headlamp
1. Open hood and support using prop rod.
2. Remove the front grille. Turn the retainers along the top 1/4 turn counterclockwise and remove.
3. Pull the bottom of the grille away starting at one side and working toward the other.
4. Turn both park and turn signal socket assemblies 1/4 turn counterclockwise and remove.
5. Remove the four screws holding the metal retaining ring.
6. Remove the lamp from the collar.
7. Grasp the bulb and turn 1/4 turn counterclockwise.
8. Pull the bulb from the housing.
9. Push connector locking tab to the unlock position.
10. Remove connector from bulb.
11. Push connector onto new bulb base, and push the connector locking tab to the lock position.
CAUTION!
Do not touch the new bulb with your fingers. Oil contamination will severely shorten
bulb life. If the bulb comes in contact with any oily surface, clean the bulb with
rubbing alcohol.
12. Reinstall bulb housing. Rotate the bulb 1/4 turn clockwise.
See also:
Help Command
If you need assistance at any prompt, or if you want to
know your options at any prompt, say “Help” following
the beep. The Uconnect™ Phone will play some of the
options at any prompt if y ...
Oil Change Required
Your vehicle is equipped with an engine oil change indicator system. The “Oil
Change Required” message will flash in the EVIC display for approximately 10 seconds
after a single chime has soun ...
Automatic Locking Retractor Mode (ALR) — If Equipped
In this mode, the shoulder belt is automatically prelocked.
The belt will still retract to remove any slack in
the shoulder belt. The Automatic Locking Mode is available
on all passenger-seating ...