To Set A Desired Speed
Turn the Electronic Speed Control ON. When the vehicle has reached the desired speed, press the SET (-) button and release. Release the accelerator and the vehicle will operate at the selected speed.
NOTE: The vehicle should be traveling at a steady speed and on level ground before pressing the SET button.
See also:
Vehicle Storage
If you are leaving your vehicle dormant for more than
21 days you may want to take steps to protect your
battery. You may:
• Remove fuse #J13 in the Totally Integrated Power
Module (TIPM) lab ...
1997 Jeep Wrangler review
A two-inch layer of ice is covering Hades this morning.
Must be, because a few years ago after driving a Jeep Wrangler and commenting
that even Mother Teresa would find fault with this vehicle, Ch ...
Front Seat Adjustment
The seat can be adjusted forward or rearward by using a bar located by the front
of the seat cushion, near the floor.
While sitting in the seat, lift up on the bar located under the seat cushion
...