After Starting
Jeep Wrangler / Jeep Wrangler Owner's Manual / Starting And Operating / Starting Procedures / After Starting
The idle speed will automatically decrease as the engine warms up.
See also:
To Set The Variance
Start the engine and leave the transmission gear selector lever in the PARK position.
Press and hold the RESET button on the steering wheel (for approximately ten seconds)
until the current varian ...
Redial
• Press the button to begin.
• After the “Ready” prompt and the following beep, say “Redial”.
• The Uconnect™ Phone will call the last number that was dialed from your mobile
phon ...
Selection Of Lubricant
Use only manufacturer’s recommended manual transmission fluid. Refer to “Fluids,
Lubricants, and Genuine Parts” in “Maintaining Your Vehicle” for further information. ...


