Hazard Warning Flashers

The Hazard Warning flasher switch is located in the switch bank below the climate controls.

Press the switch to turn on the Hazard Warning

Press the switch to turn on the Hazard Warning flasher. When the switch is activated, all directional turn signals will flash on and off to warn oncoming traffic of an emergency. Press the switch a second time to turn off the Hazard Warning flashers.

This is an emergency warning system and it should not be used when the vehicle is in motion. Use it when your vehicle is disabled and it is creating a safety hazard for other motorists.

When you must leave the vehicle to seek assistance, the Hazard Warning flashers will continue to operate even though the ignition is placed in the OFF position.

NOTE: With extended use the Hazard Warning flashers may wear down your battery.

    See also:

    Closing Sunroof — Manual Mode
    To close the sunroof, press and hold the switch in the forward position. Any release of the switch will stop the movement and the sunroof will remain in a partially closed condition until the sw ...

    2011 Jeep Grand Cherokee review
    It's been a long time coming, but the redesigned 2011 Jeep Grand Cherokee is finally here. It couldn't come soon enough for Chrysler, which is desperately in need of new products to give consumers ...

    Towing Requirements – Trailer Brakes
    − Do not interconnect the hydraulic brake system or vacuum system of your vehicle with that of the trailer. This could cause inadequate braking and possible personal injury. − An elect ...