Normal Starting

NOTE: Normal starting of either a cold or a warm engine is obtained without pumping or pressing the accelerator pedal.

Turn the ignition switch to the START position and release when the engine starts. If the engine fails to start within 10 seconds, turn the ignition switch to the LOCK position, wait 10 to 15 seconds, then repeat the “Normal Starting” procedure.

See also:

Tire Pressure Monitor System (TPMS)
The Tire Pressure Monitor System (TPMS) will warn the driver of a low tire pressure based on the vehicle recommended cold placard pressure. The tire pressure will vary with temperature by about ...

General Information
The Sentry Key system complies with FCC rules Part 15 and with RSS-210 of Industry Canada. Operation is subject to the following conditions: • This device may not cause harmful interference. â ...

Operating Instructions/Precautions
The transfer case provides four mode positions: • 2H (Two-wheel drive high range) • 4H (Four-wheel drive high range) • N (Neutral) • 4L (Four-wheel drive low range) Four-Wheel Drive Shi ...